Universal Robots e-Series Error Code C743A10: The position of external axis at index {unsigned} was commanded to move

Universal Robots Robot Minor System

Model: e-Series (UR3e/UR5e/UR10e/UR16e/UR20/UR30) | Code: C743A10

Applicable Systems
UR3 UR5 UR10 UR3e UR5e UR10e UR16e UR20 UR30

Symptoms

without the axis enabled. An axis must be enabled before it can be moved.

Possible Causes

  • without the axis enabled. An axis must be enabled before it can be moved.

Troubleshooting Steps

  1. Step 1: Enable the axis and try again.
    Check if the issue is resolved after this step

How to Reset

Power cycle the robot controller and perform a complete reboot sequence. If the error persists, update the software to the latest version.

Related Universal Robots Fault Codes

Comments (0)

Share your experience to help others facing the same problem.

No comments yet. Be the first to share your experience!

Leave a Comment

Source: Universal Robots Official Error Codes Directory (https://www.universal-robots.com/manuals/EN/PDF/Shared/ErrorCodes/ErrorCodes.pdf)

Category: Robot