Applicable Systems
MicroFlex
Symptoms
The MicroFlex reports a safety function activation. The safety circuit was triggered, removing motor torque and halting the drive.
Possible Causes
- Safety input signal activated by an external safety relay or E-stop
- Safety relay wiring fault causing false trigger
- Safety function configuration does not match the application requirements
Troubleshooting Steps
- Step 1: Check the safety input wiring and verify the safety relay status
Safety relay is in the expected state - Step 2: Verify the safety function configuration parameters in the drive
Safety configuration matches the application - Step 3: Reset the safety circuit by clearing the E-stop and cycling the safety relay
Safety function releases and motor torque is restored
How to Reset
To reset: Clear the safety condition and reset the safety relay, then restart.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Baldor MicroFlex Drive Manual, Baldor Electric Company/ABB
Category: PLC & VFD
No comments yet. Be the first to share your experience!