Applicable Systems
TwinCAT NC
Symptoms
An invalid length was specified. The length exceeds the maximum or is below the minimum.
Possible Causes
- Length parameter is outside the acceptable bounds
- Memory corruption or data structure mismatch affecting the length
Troubleshooting Steps
- Step 1: Check the calling code for correct length values
Invalid length value is identified - Step 2: Verify the data structure or protocol specification matches the expected format
Data structure matches specification
How to Reset
To reset: Correct the length value in the calling application and retry the operation.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Beckhoff TwinCAT System Manual, Beckhoff Automation
Category: PLC & VFD
No comments yet. Be the first to share your experience!