Caterpillar CID 42 FMI 6 - Engine Oil Temperature Sensor Current Above Normal/Grounded Circuit

Caterpillar Heavy Equipment Major Engine

Model: Caterpillar Heavy Equipment | Code: 42-6

Applicable Systems
EMCP 4.2

Symptoms

The Caterpillar equipment displays fault code CID 42 FMI 6 on the instrument panel or diagnostic display. The engine oil temperature sensor has reported: current above normal/grounded circuit. The check engine or warning indicator may illuminate. Equipment performance may be degraded.

Possible Causes

  • Engine Oil Temperature Sensor sensor or component fault - current above normal/grounded circuit
  • Wiring harness damage, corrosion, or loose connection
  • Connector water intrusion or pin corrosion
  • ECM input/output circuit fault
  • Mechanical failure of the monitored component

Troubleshooting Steps

  1. Step 1: Connect Caterpillar ET (Electronic Technician) or EST diagnostic tool and read all active and logged fault codes
    All fault codes are retrieved with CID, FMI, and module information
  2. Step 2: Inspect the wiring harness and connector for the CID component for damage, corrosion, or loose pins
    Wiring and connector are in good condition
  3. Step 3: Use a digital multimeter to check the Engine Oil Temperature Sensor signal voltage, ground, and 5V reference per Caterpillar service manual
    Values match specifications in the service manual
  4. Step 4: Perform component-level testing: check sensor resistance, actuator operation, or mechanical function as applicable
    Component passes or fails definitively
  5. Step 5: Clear codes and operate equipment to verify the fault does not return
    Code does not return and system operates normally

How to Reset

To reset CID 42 FMI 6: 1) Repair the underlying fault. 2) Use Caterpillar ET to clear logged and active codes. 3) Cycle the key switch (off for 10 seconds, then on). 4) Operate equipment to verify. 5) If code returns, continue diagnosis. Caution: Do not clear codes without fixing the root cause.

Frequently Asked Questions

  • Q: What does Caterpillar CID 42 FMI 6 mean?

    CID 42 identifies the Engine Oil Temperature Sensor. FMI 6 indicates: Current Above Normal/Grounded Circuit. This is a Caterpillar diagnostic code from the J1939/SAE standard.

  • Q: How serious is CID 42 FMI 6?

    Severity: Major. Reduce equipment load and schedule service.

  • Q: Can I continue operating with CID 42 FMI 6?

    Reduce load and proceed cautiously to a service location.

Related Caterpillar Fault Codes

Source: Caterpillar Service Information System (SIS), J1939/SAE Standard - verified via BING International

Category: Heavy Equipment