Applicable Systems
PowerCommand
Symptoms
Warning - Cam sensor fault. The camshaft position sensor is not providing a signal.
Possible Causes
- Camshaft position sensor failure
- Sensor wiring damaged or disconnected
Troubleshooting Steps
- Step 1: Check the camshaft sensor signal with an oscilloscope
No signal from the sensor - Step 2: Inspect the sensor wiring and replace the sensor
New sensor provides a clean signal
How to Reset
To reset: Replace the cam sensor, then acknowledge the warning.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Cummins Power Generation Control Manual, Cummins Inc.
Category: Generator
No comments yet. Be the first to share your experience!