Applicable Systems
Power Wave ACDC1000SD
Symptoms
The lubrication system reports a reservoir heater fault. The reservoir oil heater is not functioning.
Possible Causes
- Heater element burned out
- Heater wiring or terminal corroded
- Heater thermostat or control failure
Troubleshooting Steps
- Step 1: Test the heater element for continuity
Element shows correct resistance - Step 2: Inspect heater wiring and terminals
Wiring is intact and terminals are clean - Step 3: Verify the heater thermostat operation
Thermostat controls the heater correctly
How to Reset
To reset: Repair or replace the reservoir heater, then clear the alarm.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Lincoln Lubrication System Manual, Lincoln Industrial
Category: Hydraulic & Pneumatic
No comments yet. Be the first to share your experience!