Applicable Systems
DVP
AH500
AS300
C2000
MS300
Symptoms
The expansion module capacity does not match the configuration. The module cannot operate as configured.
Possible Causes
- Module with wrong I/O count installed
- Configuration specifies more channels than the module supports
Troubleshooting Steps
- Step 1: Check the module I/O capacity versus the configuration
Capacity mismatch is identified - Step 2: Install the correct module or adjust the configuration
Module capacity matches configuration
How to Reset
To reset: Install the correct capacity module or update the configuration, then power-cycle.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Delta DVP PLC Programming Manual, Delta Electronics
Category: PLC & VFD
No comments yet. Be the first to share your experience!