Applicable Systems
GTM
Symptoms
The weaving machine reports a leno fault. The leno or crossing edge mechanism is not operating correctly.
Possible Causes
- Leno drive mechanism binding
- Leno yarn tension incorrect
- Leno timing out of synchronization
Troubleshooting Steps
- Step 1: Inspect the leno drive mechanism
Mechanism moves freely - Step 2: Verify the leno yarn tension
Tension is correct for the yarn - Step 3: Check the leno timing synchronization
Timing is correct relative to the main shaft
How to Reset
To reset: Repair the leno mechanism, then clear the alarm.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Picanol Weaving Machine Manual, Picanol NV
Category: Textile
No comments yet. Be the first to share your experience!