Applicable Systems
PSE200/PSE201
Symptoms
The pneumatic system reports an air leak detection. An air leak has been detected in the system.
Possible Causes
- Fitting loose or improperly sealed
- Tube damaged or cracked
- O-ring seal damaged or missing
Troubleshooting Steps
- Step 1: Use soapy water to locate the leak
Leak location is identified - Step 2: Tighten or replace the leaking fitting
Fitting is tight and leak-free - Step 3: Replace damaged tubes or O-rings
All connections are sealed
How to Reset
To reset: Repair the air leak, then clear the alarm.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: SMC Pneumatic Equipment Manual, SMC Corporation
Category: Hydraulic & Pneumatic
No comments yet. Be the first to share your experience!