Applicable Systems
Engel Victus
Symptoms
The injection molding machine reports an ejector fault. The ejector pins are not operating correctly.
Possible Causes
- Ejector hydraulic valve failure
- Ejector pin bent or jammed
- Ejector limit switch malfunction
Troubleshooting Steps
- Step 1: Test the ejector hydraulic valve operation
Valve operates correctly - Step 2: Inspect ejector pins for bending or jamming
Pins move freely - Step 3: Verify the ejector limit switch function
Switch detects position correctly
How to Reset
To reset: Repair the ejector system, then clear the alarm.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Engel Injection Molding Machine Manual, Engel Austria GmbH
Category: Injection Molding
No comments yet. Be the first to share your experience!