Applicable Systems
Engel Victus
Symptoms
The injection molding machine reports a hopper material level low. The material supply in the hopper is low.
Possible Causes
- Material supply depleted in the hopper
- Material feed system malfunction
- Material level sensor calibration issue
Troubleshooting Steps
- Step 1: Check the material level in the hopper
Hopper is filled above minimum - Step 2: Verify the material feed system operation
Feed delivers material to the hopper - Step 3: Check the level sensor calibration
Sensor detects level correctly
How to Reset
To reset: Replenish material in the hopper, then clear the alarm.
Source: Engel Injection Molding Machine Manual, Engel Austria GmbH
Category: Injection Molding