Applicable Systems
Engel Victus
Symptoms
The injection molding machine reports a hold time completion alarm. The holding pressure phase has completed.
Possible Causes
- Normal process cycle completion notification
- Hold time parameter set too short
- Process recipe change during operation
Troubleshooting Steps
- Step 1: Verify the hold time parameter matches the recipe
Parameter is correct for the part - Step 2: Check the process cycle timing
Cycle completes correctly - Step 3: Adjust the hold time if needed
Part quality is consistent
How to Reset
To reset: Acknowledge the cycle completion, then clear the alarm.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Engel Injection Molding Machine Manual, Engel Austria GmbH
Category: Injection Molding
No comments yet. Be the first to share your experience!