Applicable Systems
Engel Victus
Symptoms
The injection molding machine reports a safety door not closed. A safety guard is open, preventing machine operation.
Possible Causes
- Safety door left open during operation or setup
- Safety door switch damaged or misaligned
- Safety relay circuit fault
Troubleshooting Steps
- Step 1: Verify all safety doors are fully closed
All doors are closed and latched - Step 2: Check safety door switch alignment
Switches engage correctly - Step 3: Test the safety relay circuit
Circuit is complete and functional
How to Reset
To reset: Close all safety doors, then reset the safety circuit.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Engel Injection Molding Machine Manual, Engel Austria GmbH
Category: Injection Molding
No comments yet. Be the first to share your experience!