Applicable Systems
Engel Victus
Symptoms
The injection molding machine reports a hydraulic pump anomaly. The hydraulic pump is not delivering adequate pressure or flow.
Possible Causes
- Pump internal wear reducing efficiency
- Pump inlet filter clogged
- Hydraulic system leak causing pressure loss
Troubleshooting Steps
- Step 1: Check the pump output pressure and flow
Pump delivers rated performance - Step 2: Inspect and clean the inlet filter
Filter is clean and flow is unrestricted - Step 3: Verify the system has no leaks
No leaks found in the hydraulic system
How to Reset
To reset: Restore hydraulic pump performance, then clear the alarm.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Engel Injection Molding Machine Manual, Engel Austria GmbH
Category: Injection Molding
No comments yet. Be the first to share your experience!