Applicable Systems
Engel Victus
Symptoms
The injection molding machine reports insufficient cooling time. The mold cooling time is below the minimum for safe part ejection.
Possible Causes
- Cooling time parameter set too short
- Mold temperature too high for the cycle
- Part geometry requiring longer cooling
Troubleshooting Steps
- Step 1: Verify the cooling time parameter
Time is adequate for part solidification - Step 2: Check the mold temperature
Temperature is within the correct range - Step 3: Adjust cooling time for the part geometry
Parts eject without deformation
How to Reset
To reset: Adjust the cooling time, then clear the alarm.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Engel Injection Molding Machine Manual, Engel Austria GmbH
Category: Injection Molding
No comments yet. Be the first to share your experience!