Applicable Systems
YLS-2000
Symptoms
The fiber laser reports a communication interruption. The link between the laser controller and the host is lost.
Possible Causes
- Communication cable disconnected or damaged
- Network interface hardware fault
- Protocol or IP address configuration error
Troubleshooting Steps
- Step 1: Check the communication cable connections
Connections are secure at both ends - Step 2: Verify the network interface status
Interface shows normal operation - Step 3: Check the IP address and protocol settings
Settings match the host configuration
How to Reset
To reset: Restore the communication link, then reset the laser controller.
Source: IPG Fiber Laser User Manual, IPG Photonics Corporation
Category: Laser